Indesit K6T52S(X)/AUS Instruções de Utilização descarregar pdf (Página 6)

AUS

Adapting to different types of gas

It is possible to adapt the appliance to a type of

gas other than the default type (this is indicated on

the rating label on the cover).

Adapting the hob

Replacing the nozzles for

the hob burners:

1. Remove the hob grids

and slide the burners off

their seats.

2. Unscrew the nozzles

using a 7 mm socket

spanner (

see figure

), and replace them with

nozzles suited to the new type of gas (

see

Technical Specifications table

3. Replace all the components by following the

above instructions in reverse.

Adjusting the hob burners’ minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory

screw, which is positioned inside or next to the tap

pin, until the flame is small but steady.

! If the appliance is connected to a liquid gas

supply, the regulatory screw must be fastened as

tightly as possible.

3. While the burner is alight, quickly change the position

of the knob from minimum to maximum and vice versa

several times, checking that the flame is not

extinguished.

! The hob burners do not require primary air adjustment.

! After adjusting the appliance so it may be used

with a different type of gas, replace the old rating

label with a new one that corresponds to the new

type of gas (these labels are available from

Authorised Technical Assistance Centres).

! Should the gas pressure used be different (or

vary slightly) from the recommended pressure, a

suitable pressure regulator must be fitted to the

inlet hose in accordance with current national

regulations relating to “regulators for channelled

gas”.

Post Installation Checks

Perform post installation checks and ensure proper and

safe operation before leaving. Test all burners

individually and in combination.

Leak Check

• Ensure all gas control knobs are in the Off position.

• Ensure the gas supply is switched on.

• Spray a solution of soapy water onto all gas joints as

well as the full length of any flexible hoses.

UNDER NO CIRCUMSTANCES USE A NAKED FLAME

IN CHECKING FOR LEAKS.

If bubbles appear anywhere, turn the gas supply off,

check all connections and retest. If satisfactory

operation cannot be achieved, contact place of

purchase or their appointed agent for service.

Flame check

Turn each burner on, and ensure that the flame is blue

with minimal yellow tipping. If there is significant yellow

tipping, flame lift off or excessive noise, check pressure

and adjust at the regulator if necessary.

If satisfactory operation cannot be achieved, contact

place of purchase or their appointed agent for service.

Igniter operation

Check that the igniter for each burner successfully

ignites the gas.

If an igniter fails to work, first remove the plug from the

electrical power outlet, and then check that all the

electrical connections are in place.

If satisfactory operation cannot be achieved, contact

place of purchase or their appointed agent for service.

Low flame setting

Check the low flame setting for each hob burner to

ensure that the minimum flame will not be extinguished

by air draughts.

• Light the burner.

• Turn the control until it engages in the minimum

position.

• Ensure the flame is stable and will not be

extinguished by air draughts.

To adjust the minimum flame:

Follow the procedure described in the gas conversion

instruction.

DO NOT MODIFY THIS APPLIANCE IN ANY WAY,

OTHER THAN AS DESCRIBED IN THESE

INSTRUCTIONS.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comentários a estes Manuais

Sem comentários

Indesit K6T52S(X)/AUS Instruções de Utilização Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Indesit K6T52S(X)/AUS